Hello team, I need your insights on the recent incident we had on our IC. What happened was that one of our analysts set a wrong suppressor current (50mA) for a sequence using 35mM KOH as el...
Dear Community, We had an issue with the conductivity detector, so I am looking for any idea and/or related troubleshooting experience. What happened is that the baseline signal is periodica...
Dear Community, For the proper IC configuration very important the right suppression choice. In this case the official guideline is very good: https://assets.thermofisher.com/TFS-Assets/CMD/brochu...
Dear Community,
The goal anion (F, Cl, NO2, NO3, SO4, PO4) analysis in domestic wastewater (particules, hydrophobic matrices)
We have to reach LOD 50 ug/L for nitrite, for the others the...
Dear IC Community, I would like measure iodate, periodate. I fould one application (what is no MS detection) for iodate determination, based on IC-PAD (AN37). The Virtual Column Simulator shows co...
Hello, Is it possible to measere hypochlorite (ClO-) anion (high dilution, low level concentration, ppb-ppm range) with the following setup, KOH EG, AS19 column, ADRS 600 suppressor, CD detector? I...
Hello, The analytical task is to measure anions and cations (not transition metals) with IC from plating bath solutions. This solutions contains high level of transition metals, what could make pro...